Teldat bintec W1002n Manuel d'utilisateur Page 167

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 554
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 166
Field Description
Displays the second channel used.
Bandwidth Only for Wireless Mode = 44, 4,
, 4
Select how many channels are to be used.
Possible values:
 =;D (default value): One channel with 20 MHz bandwidth
is used.
' =;D: Two channels each with 20 MHz bandwidth are
used. In the case one channel acts as a control channels and
the other as an expansion channel.
Number of Spatial
Streams
Only for Wireless Mode = 44, 4,
, 4
Select how many traffic flows are to be used in parallel.
Possible values:
(: Three traffic flows are used.
: Two traffic flows are used.
: One traffic flow is used.
Max. Link Distance Only for Operation Mode = *
Enter the maximum link range.
If the +  option is enabled, the automatically gener-
ated range is used.
If this option is not enabled, enter the desired maximum value in
the m field.
Option +  is active by default.
Transmit Power Select the maximum value for the radiated antenna power. The
actually radiated antenna power may be lower than the maxim-
um value set, depending on the data rate transmitted. The max-
imum value for Transmit Power is country-dependent.
Possible values:
Teldat GmbH
10 Wireless LAN
bintec WLAN and Industrial WLAN 153
Vue de la page 166
1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 553 554

Commentaires sur ces manuels

Pas de commentaire