Teldat bintec W1002n Manuel d'utilisateur télécharger pdf (Page 539)

100

101

Signalling 1) phones.

V.11 ITU-T recommendation for balanced dual-current interface lines (up

to 10 mbps).

V.24 CCITT and ITU-T recommendation that defines the interface

between a PC or terminal as Data Terminal Equipment (DTE) and a

modem as Data Circuit-terminating Equipment (DCE).

V.28 ITU-T recommendation for unbalanced dual-current interface line.

V.35 ITU-T recommendation for data transmission at 48kbps in the range

from 60 to 108kHz.

V.36 Modem for V.35.

V.42bis Data compression procedure.

V.90 ITU standard for 56 kbps analogue modems. In contrast to older

V.34 modems, data is sent in digital form to the client when the V.90

standard is used and does not need to be first converted from digital

to analogue on one side of the modem (provider), as was the case

with V.34 and earlier modems. This makes higher transmission

rates possible. A maximum speed of 56 kbps can be achieved only

under optimum conditions.

Vanity Letter dialling

VDSL Very high bit rate digital subscriber line (also called VADSL or BD-

SL).

VID VLAN ID

VJHC Van Jacobson Header Compression

VLAN Virtual LAN

VoIP Voice over IP

VPN Virtual Private Network

VSS Virtual Service Set

WAN Wide Area Network

WAN interface WAN interface

WAN partner Remote station that is reached over a WAN, e.g. ISDN.

Teldat GmbH

Glossary

bintec WLAN and Industrial WLAN 525

1 2 ... 534 535 536 537 538 539 540 541 542 543 544 ... 553 554

Commentaires sur ces manuels

Pas de commentaire

Teldat bintec W1002n Manuel d'utilisateur Page 539

Commentaires sur ces manuels