Teldat bintec RT1202 Manuel d'utilisateur télécharger pdf (Page 170)

100

101

13.1.2 Radio Profile

Select which frequency band your WLAN controller shall use.

If the  ?G @ !, is set then the 2.4 GHz frequency band is used.

If the  ?G @ !, is set then the 5 GHz frequency band is used.

If the corresponding device contains two wireless modules, you can Use two independent

radio profiles. This assigns  ?G @ !, to module 1 and  ?G @

!, to module 2.

The function is activated by selecting ,.

The function is disabled by default.

13.1.3 Wireless Network

All of the configured wireless networks (VSS) are displayed in the list. At least one wireless

network (VSS) is set up. This entry cannot be deleted.

Click on to edit an existing entry.

You can also delete entries using the icon.

With Add, you can create new entries. You can create up to eight wireless networks (VSS)

for a wireless module.

Note

If you wish to use the default wireless network that is set up, you must at least change

the Preshared Key parameters. Otherwise you will be prompted.

13.1.3.1 Change or add wireless networks

Click on to edit an existing entry.

With Add, you can create new entries.

The following parameters are available

Network Name (SSID)

Enter the name of the wireless network (SSID).

13 Wireless LAN Controller Teldat GmbH

156 bintec Rxxx2/RTxxx2

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 621 622

Commentaires sur ces manuels

Pas de commentaire

Teldat bintec RT1202 Manuel d'utilisateur Page 170

Commentaires sur ces manuels