Teldat bintec RT1202 Manuel d'utilisateur télécharger pdf (Page 362)

100

101

Field Description

The function is enabled by default.

Block Time Define how long a peer is blocked for tunnel setups after a

phase 1 tunnel setup has failed. This only affects locally initiated

setup attempts.

Possible values are  to  (seconds);  means the

value in the default profile is used and  means that the peer is

never blocked.

The default value is $.

NAT Traversal NAT Traversal (NAT-T) also enables IPSec tunnels to be

opened via one or more devices on which network address

translation (NAT) is activated.

Without NAT-T, incompatibilities may arise between IPSec and

NAT (see RFC 3715, section 2). These primarily prevent the

setup of an IPSec tunnel from a host within a LANs and behind

a NAT device to another host or device. NAT-T enables these

kinds of tunnels without conflicts with NAT device, activated

NAT is automatically detected by the IPSec Daemon and NAT-T

is used.

Only for > )!,#

Possible values:

• , (default value): NAT Traversal is enabled.

• .#,: NAT Traversal is disabled.

• 9": The device always behaves as it would if NAT were in

use.

Only for > )!,#

The function is enabled with ,.

The function is enabled by default.

CA Certificates Only for Phase-1 (IKE) Parameters

Only for Authentication Method = .*- * 3, @*-

* 3 or @*- "&)

If you enable the Trust the following CA certificates option,

18 VPN Teldat GmbH

348 bintec Rxxx2/RTxxx2

1 2 ... 357 358 359 360 361 362 363 364 365 366 367 ... 621 622

Commentaires sur ces manuels

Pas de commentaire

Teldat bintec RT1202 Manuel d'utilisateur Page 362

Commentaires sur ces manuels