Teldat bintec RT1202 Manuel d'utilisateur télécharger pdf (Page 198)

100

101

13.4.5 Rogue APs

Fig. 73: Wireless LAN Controller->Monitoring->Rogue APs

APs which are using an SSID from their own network but are not managed by Wireless

LAN Controller are displayed in the Wireless LAN Controller->Monitoring->Rogue APs

menu. Rogue APs which have been found for the first time are displayed with a red back-

ground.

For each rogue AP you will see an entry with the following parameter set: SSID, MAC Ad-

dress, Signal dBm, Channel, Last seen, Detected via AP,Accepted.

Note

Check the rogue APs shown carefully, as an attacker could attempt to spy on data in

your network using a rogue AP.

You can class a rogue AP as trustworthy by enabling the Accepted checkbox. If an alarm

has been configured, this is then removed and no longer sent. The red background disap-

pears.

Click under New Neighborscan on Start, to rescan adjacent AP's. You will receive a warn-

ing that the wireless modules of the access points must also be disabled for a certain peri-

od of time. When you start the process with OK, a progress bar is displayed. The located

AP display is updated every ten seconds.

13 Wireless LAN Controller Teldat GmbH

184 bintec Rxxx2/RTxxx2

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 621 622

Commentaires sur ces manuels

Pas de commentaire

Teldat bintec RT1202 Manuel d'utilisateur Page 198

Commentaires sur ces manuels